Electronics Forum | Fri Apr 27 12:41:41 EDT 2018 | irc
Thanks for the answer, but the problem is the blue button is tur on all the time and I need turn of for work whit the oven. Best Regards.
Electronics Forum | Thu Aug 01 15:50:15 EDT 2002 | pjc
I had a 1995 SENSBEY MXL-400J at the last place I worked. I had very good results- easy to setup, run and maintain. It has a paint gun type spray head. Good idea to have spares cause they can clog. I sprayed a Multicore NC flux. Only downer was a fai
Electronics Forum | Wed Apr 25 14:10:00 EDT 2018 | irc
hello, I'm learning to use the oven 1809 exl and when I try to put it on the Estop button is on all the time and allows use of the oven I read in the manual but I can not find an answer to deactivate it, could you tell me how I can disable this butto
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Sat Jan 01 10:14:30 EST 2005 | davef
East coast, solder connection failure analysis labs in the vacinity of New England are: * American Competitiveness Institute, Electronics Manufacturing Productivity Facility, One International Plaza - Suite 150, Philadelphia, PA 19113(610) 362-1200 F
Electronics Forum | Fri Jul 15 16:31:40 EDT 2005 | davef
We don't know of a laboratory that meets your requirements, but we'd start looking here: * Robisan Laboratory 6502 East 21 St Indianapolis, IN 46219 317-353-6249 fax 357-1270 Susan Mansilla, Technical Director robisan1@aol.com * Trace Laboratories -
Electronics Forum | Mon Sep 27 20:14:37 EDT 2021 | cbeneat
For what it's worth, we have 5 Vitronics ovens. XPM2, 2+, 3I, 3M. Our Oldest is an XPM2-1030 as mentioned. We have never replaced a fan motor. We've been running it for 3 shifts for 16 years. A couple of the gearboxes for the conveyor width have been
Electronics Forum | Wed Jun 28 22:34:31 EDT 2006 | davef
Yes, it would. That you are asking this question makes us wonder if you would be better advised to contract with a independent FA laboratory to help you baseline your analysis. Among the fine labs to consider are: * Robisan Laboratory 6502 East 21
Electronics Forum | Mon Apr 19 11:26:32 EDT 2010 | davef
Independent Labs * American Competitiveness Institute; One International Plaza Suite 600, Philadelphia, PA 19113; 610-362-1200 F1290 info@aciusa.org * Bodycote Materials Testing , 847-676-2100, na.bodycote-mt.com * Foresite 765-457-8095, http://www
Electronics Forum | Thu Aug 18 14:13:36 EDT 2011 | davef
Here are a few labs that would be good starting points: * Robisan Laboratory; 6502 East 21 St, Indianapolis, IN 46219; 317-353-6249 F357-1270 Susan Mansilla, Technical Director robisan1@aol.com * Trace Laboratories - East; 5 North Park Dr, Hunt Vall
