Electronics Forum | Wed Oct 13 05:26:54 EDT 2010 | Jack
Hi All Is here any1 can tell me how to get the installation guideline of Semi-Auto Stencil Printer,SMT brand SL 2220? Thanks in advance.
Electronics Forum | Thu Dec 02 01:24:06 EST 2010 | jucki
Hi All If whoever has used before SMT SL2220 semi-auto printing, please let me know and discuess how to run it properly. I'm not so convenient to use it. Please share knowledge with me. Thanks
Electronics Forum | Thu Oct 14 22:01:18 EDT 1999 | JEff
Is there a equirement on how clean an area/room should be?
Electronics Forum | Sat Aug 29 15:41:51 EDT 2020 | joycehughes
Does anyone have a copy of a Surface Mount Techniques SL2220 manual?
Electronics Forum | Mon May 15 20:10:27 EDT 2000 | Dave F
David: How about starting with MCMs? IPC docs are: * 2225 - Sectional Design Standard for Organic Multichip Modules (MCM-L) and MCM-L Assemblies * DD-135 - Qualification Testing for Deposited Organic Interlayer Dielectric Materials for Multichip
Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Fri Jan 23 09:21:22 EST 2009 | sm2009
Hello, thanks to everyone that reply to my previous question. I have another request: is it possible to solder polyester capacitors (case 2220) with wave soldering process? Thanks! Regards, Stefano
Electronics Forum | Mon Oct 18 08:11:49 EDT 1999 | Graham Naisbitt
20 times per hour. Lights should be behind "Georgian wired" glass rather than Ex'd' and all electrics should be hard-wired. Zone the room 1 = safest = around the coating machine and drying cupboards 1 meter from material. Zone 2 = > 1 meter away = OK
Electronics Forum | Mon Mar 08 21:53:48 EST 2010 | aungthura
We have been using a manual printer for both epoxy and solder paste.Now, our buyer asked us to replace it with 2nd hand SMT SL 2220 stencil printer.Our board size is usually 450x550mm and thousnds of compenents.I want to know that some1 has used this
Electronics Forum | Wed Dec 13 10:24:52 EST 2000 | Wolfgang Busko
Hi Jack, I once tried this finish ( without changing any process parameters ) and encountered wetting problems even in the first reflow process. It was thought as cheaper alternative to Ni/Au we use for planarity reasons. Heard of the same problems
