Electronics Forum | Sat Sep 22 20:20:13 EDT 2012 | dekhead
You don't say which 265; presumbly since you say "bulb" it is either MK1 or GS with shuttered camera. Both those machines have potentiometers to control light levels. MK1 is on machine frame inside drop down (stencil load) door, near serial tag. GS
Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Thu May 20 09:20:08 EDT 2004 | jsk
Voltage checks out ok after i unplug the monitor and unplug the dc voltage suppy to the y1 enclosure. I lose the 24v and 5v line completely when i plug these in and voltage drops on the +12v and -12v, which leads me to believe a bad power suppy. What
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Tue May 09 08:46:43 EDT 2006 | eyryren
This is Shenzhen comofaje Tech.co.,Ltd from China mainland We are the Associator of Hi-tech industry Association, so I think we can become your supplier in China. Now we have Four series products:1 SMT stencil wiping roll/wiper special for FUJI MPM
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
Electronics Forum | Fri Feb 05 12:25:37 EST 2010 | baildl632
Yes, it's powered up. We use a simple power supply that connects directly to the drive. It spins up fine. I belive my problem is with Windows not recognizing the old type of drive correctly. It does recognize it as a mass storage device (the drivers
Electronics Forum | Thu Aug 23 09:44:09 EDT 2018 | midware
Hi. Please help. On DEK 265 GSX i've got on the monitor message: "DEK 265 GSX Motor comms failure, card 1, axis 123 fatal error." F1-F8 doesn't work, machine cant start. No result after Reinitialise machine. Which one is this card1? Is it in PC?
winsouce.jpg)
