Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Wed Jun 22 15:35:09 EDT 2016 | mikemoriel
Hi all, I have a problem on my 265 GSX printer. "Position error" on the rising table. Machine was running fine and then out of the blue the error occurs, takes a few power downs and not working... The table does not move then error occurs...
Electronics Forum | Wed Jun 22 16:44:20 EDT 2016 | travishemen
It could be the brake for the rising table. I don't remember if it runs on 44 volts but if it is bad it will prevent the table from moving and may blow the fuse.
Electronics Forum | Fri Jul 26 07:21:07 EDT 2013 | falvarez
thanks!! confirmed!
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Wed Oct 23 10:00:13 EDT 2013 | aj
All, I am glad to report that this issue has been resolved at last. Issue with 40VAC contact in the Y4 crate, as the problem was intermittent it was a difficult one to trace/prove. My thanks to DEKHEAD for assistance and Maxem Engineering..... PS
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Thu Jul 25 14:44:34 EDT 2013 | falvarez
Im needing an Rising table motor for Dek Horizon, but with a 4000 count encoder, because that motor i bought become with a 1000 count encoder and not worked. any suggestion?
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
.gif)
