Electronics Forum | Tue Jan 10 19:01:13 EST 2012 | carvincorp
I was wondering if anyone else out there using the Vectorguard system by DEK has had problems with leaking air bladders. We started using a 29 x 29 frame about a year ago, and already, we've needed to send the frame back 3 times for repair due to int
Electronics Forum | Wed Jan 11 10:22:42 EST 2012 | swag
We had same trouble with one (different mfg.). Sent it back 3 or 4 times for repair. Turned out to be a small burr in the machining on the internal parts that house the air bladder. Same thing happens if you have a burr on a bicycle tire rim. Tou
Electronics Forum | Fri Apr 27 09:41:44 EDT 2018 | cyber_wolf
Typically freezing and air conditioners equals a low charge.
Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo
This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.
Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas
hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Tue Nov 07 09:59:21 EST 2006 | realchunks
Well, there you have it. When deciding between MPM or DEK, you should choose..... Ekra! Wow, um, thanks for clearing the air on that one Tyrone.
Electronics Forum | Thu Oct 05 16:45:19 EDT 2006 | realchunks
Wow, I'd have to say the exact opposite. Compared to MPM the DEKs were WAY longer to program. But find out for yourself CN. Program each and get back to us. Don't forget to program in 2D as well. That will be the kicker! As for spending money,
Electronics Forum | Sun Sep 25 16:40:09 EDT 2011 | cbroegger
Have been through the same problem with the eurostep cards. The missing communications with the cards, suggest that some acid leaked from the batteries have etched tracks/and or the serial converters (soic8) on the cards. In all cases, clean the card
Electronics Forum | Thu Apr 28 00:19:52 EDT 2016 | ttheis
I'm not personally familiar with the 265 but it sounds like the machine's board stop actuator is not retracting or a sensor that detects that actuator position is stuck (probably a reed switch.) If your stop is not retracted, then the sensor is telli
winsouce.jpg)