Electronics Forum | Fri Jan 28 14:07:00 EST 2005 | davef
We're not in Chicago, nor are most of the used equipment contacts listed below. Why is that important? * Broome Engineering, 1010 Conklin Rd. Conklin NY 13748 607 779 5142 fax 7799 Lou Pixley Sales Engineer * Insertech 2398 N Penn Rd, Unit 3, Hatfie
Electronics Forum | Mon Feb 28 16:04:30 EST 2005 | Alex
I use to have that kind of problems with other type of machines and here are the causes: 1- Spray fluxer head partially obstructed (check flow rate) 2- Defective pre-heater probe (manually check temps) 3- PROFILE (last preheat to 280) 4- we sometimes
Electronics Forum | Sat Aug 26 12:26:57 EDT 2000 | Ramon I Garcia C
Hi friends: I have a problem in the process of one PCB, I have a lot of insuficients of solder in top of the board, this pcb already was working good, but sudenly began there isn't flow thru hole, I ran the profile and it was ok, if I inmerse i
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Wed Aug 10 16:37:35 EDT 2011 | davef
Yes, there are ways to machine process boards like this. The devil is in the detail. In no particular order, your choices are: Process flow #1: * Print chipbonder on the surface mount side for SMT parts * Mount SMT components * Cure adhesive, if r
Electronics Forum | Wed Aug 30 09:56:37 EDT 2000 | NLykus
Hi Ramon, We have had this problem before on our Seho Wave Solder Machine. We are currently using a spray fluxer as well. By imersing the PCB into the flux you stated you are getting good results. What you need to do is check your spray patter
Electronics Forum | Thu Oct 05 23:44:55 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Sun Oct 08 23:37:37 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Mon Feb 28 10:11:27 EST 2005 | jbrower
Hi Ing, My suggestion is to take a good look at your profile(s). The Wave solder machine that I use is an Electrovert EPK I. I use Aim ultra pure 63/37 solder with an older kester flux, 920CFX. I recently switched from kester ultrapure to the aim ba
Electronics Forum | Thu Jun 15 19:39:43 EDT 2006 | Bolos
nice to hear from you..my company is an ems.so need a more flexible reflow.. we have 3 lines and soon to install another line for leadfree ideally..so.. its getting a new one hopefully..a seven zone actually i think might do the job... for the wave i
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
