Electronics Forum | Tue Feb 08 06:39:36 EST 2005 | teilo
We have recently purchased a second hand cosmo injection moulding machine 300-350 tonne. Serial No 3271 Model 2288/350 HI. We have managed to get manual from Hong Kong but we are having problems with the wiring does anyone know where we can get elect
Electronics Forum | Wed Mar 27 21:20:30 EST 2002 | davef
There is two major BGA coating camps. * Camp #1: "We require the coating to be under low stand-off devices but with no filleting. So we apply a thinned dip coat first, and then top-off with a proper spray coat" * Camp #2: "We want no coating under th
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Tue Sep 28 19:22:48 EDT 2021 | kumarb
Hi. Aside from the good advice above, wish to throw in our experience with our 1809EXL. Had < 200 on-hours and the oven would not melt the assorted fresh paste we sourced from different suppliers. The s/w reported that the set temps were being
| 1 |
