Electronics Forum | Tue Mar 10 17:56:43 EST 1998 | Jeremy Smith
I am having a problem with Entek coated boards. The solder past seem to just ball up on the pads. I had no problems with the board when it was hot air leveled. The board is double sided surface mount. I have tried adjusting the oven profiles makin
Electronics Forum | Wed Mar 04 10:05:13 EST 2020 | dontfeedphils
In a past life I used a Swam Blaster from Crystal Mark with the media from them as well. I used it on Humiseal 1A31 and 1B31 (I think those were the products, it's been a little while). This machine and material were awesome IMO. Made CC removal a
Electronics Forum | Tue Oct 31 19:28:24 EDT 2023 | ttheis
We built our own coating system by mounting a Universal Robots UR5 to an edge conveyor between a magazine unloader and magazine loader. The robot has a needle dispenser on the head. We chose a needle dispense process to avoid aerosols and complex ven
Electronics Forum | Tue Jan 13 16:40:03 EST 2004 | Jacob Lacourse
Hi folks, I have a conformal coating application where I need the coating to be UV stable for a number of years without any crazing or cracking of the coating. I have looked for such a coating and have come up empty handed. Much of the circuit boar
Electronics Forum | Fri Feb 18 11:25:14 EST 2005 | davef
It's weird that it would be just 0805. When we see this it relates to a single part number and it goes way after a time. We use a Humiseal 1B73. I've emailed you the contact for a person that is very knowledgeable on conformal coatings.
Electronics Forum | Tue Jun 15 16:16:29 EDT 2004 | Igor
Our research group is looking for a more efficient method of coating a small piece of sheet metal. We have a 1.5cm x 1.5cm very thin sheet of metal that we are coating with liquid epoxy, using a brush that was provided. This method has become unacc
Electronics Forum | Mon Sep 19 09:46:32 EDT 2011 | blnorman
Hopefully the coating does contain a UV tracer. We used a silicone years ago that did not, but UV did make it fluoresce to a degree, you just couldn't ensure 100% coverage. One time we did have a problem with the coating getting on connector pins,
Electronics Forum | Fri Jun 05 00:08:32 EDT 2015 | acepa
Hi, I need a recommendation for a manufacturer on a reasonable cost conformal coating (silicone or other). This is a US domestic appliance PCB 9 volts only that must be dipped. Silicone or other could be unused. There is a standard RJ45 socket I wher
Electronics Forum | Tue Oct 31 19:37:34 EDT 2023 | ttheis
That is true; it is not a fast process but it is selective and uses minimal material. Also true that the application consistency has to be checked and sometimes minor adjustments made at the beginning of a run. We have a program that checks for a con
Electronics Forum | Mon Sep 29 16:02:33 EDT 2008 | scottd3
We are having problems with a specific lot of boards wave soldering. I need a way to prove the boards are bad, does anyone know a way to verify the amount of OSP coating on a board, or a company I can get to do it for me? I am using PBfree solder of