Electronics Forum | Wed May 20 05:50:08 EDT 2020 | tima
Hello colleagues, Question. Who ever done 4 mil (100uM) electro conductive epoxy dispensing? is it even possible? I did 6 mil but very unstable results... Now I need 4 mil for an application.
Electronics Forum | Thu Jun 25 10:56:48 EDT 2020 | kumarb
Hi. Contact PVA in the US. Our company has been a supplier to them for many years to date for the adapters used in their machines. This is their vertical. Hope this helps.
Electronics Forum | Mon Apr 07 11:39:55 EDT 2003 | russ
How thick is your stencil? We print 16mil every day with type 3 paste 2 of which you have tried (Alpha and Kester) Stencil should be 5 mil. Russ
Electronics Forum | Mon Apr 07 09:52:07 EDT 2003 | kmorris
I have just started an assembly which uses a 16 mil pitch QFP. We ran on Saturday, using a type 3 solder paste. (working Sat's really sucks) We really struggled with paste release after the stencil sat for 15 minutes without printing. Apertures clog
Electronics Forum | Mon Apr 07 13:02:30 EDT 2003 | kmorris
Sorry, I forgot to include the stencil thickness. It is 5 mil. Thanks for the input, everbody. I just checked with our stencil supplier & I thought that Electro-polish was standard with lazer, but I now find out it is not. Our stencil did not get
Electronics Forum | Mon Apr 07 12:21:02 EDT 2003 | davef
Russ is correct. A 5 thou thick stencil should give good release. Here's how you run through it: * You want at least 5 solder particles across the smallest aperture. So in your case, 8 thou wide, which equals to 0.20mm gives us 0.20/5=40 microns.
Electronics Forum | Thu Apr 29 11:07:03 EDT 2004 | arcandspark
You are right about the very poor support for smaller customers. I had told them we were looking for another paste and now they have sent the reginal manager and the US sales manager has come by to see what they can do for us. All they keep saying is
Electronics Forum | Tue Apr 13 08:25:15 EDT 2004 | arcandspark
I would have gone to a .004" stencil but again, the board designers, which we have no control over or are we allowed to give input to, have made the pads on all connectors and many other parts so small that we are almost seeing insuffecient solder us
Electronics Forum | Fri May 30 20:54:53 EDT 2003 | jonfox
Conversion refresher: 1 inch = 25.4 mm 1 inch = 25,400 microns 10 microns = 0.3937 mils 10 microns = 0.010 mm so 0.4mm = 400 microns and for s/n/g: 1mm = 3.240783e-20 parsecs (pc) Have some fun with that one!
Electronics Forum | Fri May 30 18:57:44 EDT 2003 | russ
We place a large amount of .4mm (what is that in microns?)QFPs every day. I would much prefer a BGA package. Reasons are 1. Pitch is greater which provides a larger process window 2. Alignment is easier because you don't need vision for BGA if you
winsouce.jpg)