Electronics Forum | Fri Jun 28 14:20:32 EDT 2024 | mistrthou
Ours may be different, but the back power plates (yes, there's two) show 2082/220v 50/60Hz 30A and 115/120v 50/60Hz 15A Thinking the frequency won't matter. You'd be a bit above the high side of voltage. How did you end up with a KISS over there? Th
Electronics Forum | Tue Sep 20 15:37:24 EDT 2005 | intermin
Well, at that value point, I'd go with the hourly ( unburdoned ) high-skill rework/repair rate up to 50%-60% of the board value. If this is part of an integrated system ( in-house assembly ) repair to value ratio could go even higher.
Electronics Forum | Tue Jul 30 16:26:54 EDT 2013 | jorge_quijano
It has about 50-60%, we do not have equipmet to get an accurate measurement, touch up is what we are doing for now.
Electronics Forum | Mon Apr 25 09:15:18 EDT 2016 | soldertools
Hi Adamjs! Flux or paste is controlled at a depth of 50-60% per cent of the ball diameter prior to placement of a BGA or to place a PoP component on to a board or other device. For more details visit us at Soldertools.net
Electronics Forum | Tue Jul 18 09:56:20 EDT 2017 | svfeingold
Tsvetan that really is an amazing machine. I have looked at it but assumed it was way out of my price range. Is it really possible to get a new machine with 50-60 feeders for under $100k? That sounds like a steal. What is the maximum component heig
Electronics Forum | Fri Jun 15 09:25:40 EDT 2018 | reckless
What about their dual gantry 10 head chip shooter machines? They seem to be going around $50-60k used.
Electronics Forum | Tue May 08 01:01:24 EDT 2001 | ilanl
The AOI suppliers are not tailoring the systems to the application but are defining the applicability of their system to a specific AOI segment �i.e. �leveraging� the limitation of the technology. Would a AOI supplier possess a technology that will a
Electronics Forum | Wed Aug 03 04:33:39 EDT 2005 | aj
if you have enough free space at the edge of the board you could try some titanium supports, I have to use these on some products to prevent warping. Also, in relation to profile and I know there are a lot of variables to consider but is 225 not a b
Electronics Forum | Thu Dec 15 19:47:43 EST 2005 | Liza
Hi GS, You mentioned that polystyrene should be sealed by low method. We are currently using the ffg parameters for polystyrene monolayer dull finish carrier tape and AA cover tape. Are these considered low by standard? These are the parameters r
Electronics Forum | Mon Feb 20 08:25:13 EST 2006 | Rob
No problem. If you get no joy you're going to have to change the footprint to a 1206 or 1210. Murata have a range of high Q value inductors (50-60) & from memory Toko used to be pretty hot too. The terminations on the coilcraft part are listed a
