Electronics Forum | Fri Dec 10 11:36:44 EST 2010 | reic1
We just recently purchased a Dynapace 48" conveyor with digital display. Am in need of operation and maintenance manuals. Any assistance would be greatly appreciated. Thank you!
Electronics Forum | Wed Feb 12 17:10:02 EST 2003 | Mike G
Most conveyors are sold by the inch. I allow for no more than one inch gap between the end of the conveyor and the next piece of equipment. If you trust your measurements, 1/2 inch is best. This will allow for the smoothest transfer possible of small
Electronics Forum | Thu Feb 15 16:58:11 EST 2007 | flipit
Phil, I used to print solder paste on 2" X 2" and 3" X 3" 96% Alumina substrates all the time. I used standard solder printers and stencils. Screens are difficult to use and don't print well. You can use a stencil on a DeHart, CW Price, or AMI Pr
Electronics Forum | Tue Feb 23 09:26:34 EST 2016 | tombstonesmt
Good to hear! Never dealt with an assembly that large. 24" is the longest we've built. One issue we encountered was bowing due to the vacuum seal being too tight. Bowing caused transfer issues between conveyors and equipment. -TSS
Electronics Forum | Wed Dec 30 11:10:53 EST 2015 | ilavu
Tom, Mount one sensor at about 6 inch inside of the beginning of the oven conveyor and use its output as ready to accept the board signal. That 6 inch distance will give you timing and space between two boards entering in the oven. Tushar
Electronics Forum | Fri Apr 12 08:44:25 EDT 2019 | kgarlapa
HELLO GUY, We are using kanetic conveyor 13inch size. The conveyor belt moves reverse direction when pcb comes. what could be the problem? Regards,
Electronics Forum | Fri Apr 12 08:51:12 EDT 2019 | kgarlapa
We are using kanetic conveyor 13inch size. The conveyor belt moves reverse direction when pcb comes. what could be the problem?
Electronics Forum | Tue Dec 16 16:14:20 EST 2003 | Bill
We are in need of a replacement conveyor belt for an unload-end conveyor(post wave solder). The part number we had at one point (formerly PCT automation) was 65-4008-4 (Belt, Flat-W=23.75 L=171.70) green high temp conveyor belt. Any help would be g
Electronics Forum | Wed Feb 02 20:00:48 EST 2005 | davef
150*C/min * Determining the distance it takes to lower the delta temperature at the current conveyor speed: [150*C/min]/[25 inch/min] = 6*C/inch * Calculating how much of this 6*C/inch would be spread along the length of the 0805 capacitor: [6*C/inch
Electronics Forum | Wed Oct 31 04:37:15 EDT 2007 | aj
Hi, My oven has 5 zones each 12 inches in length , giving a total of 70 inches Heating Zone in total. I am working with a 6 layer PCB ,ENIG Finish. I am using Alpha OM338T no-clean Solder Paste. I am working to a cycle time of 4 to 4.5mins RTS p