Electronics Forum | Mon Mar 09 16:27:46 EDT 2020 | oxygensmd
Sadly, without line controller software you won't be able to load jobs to your machines. Check your mails later.
Electronics Forum | Thu Mar 05 17:28:37 EST 2020 | sportsradar
I am desperate. I have an 80S15 with a single line controller that we program with and control our 80S15 machine. Everything has been working great until last month. We have not done any changes, and no new programs or jobs. We went to start the PC
Electronics Forum | Tue Mar 17 09:09:34 EDT 2020 | emeto
You should be able to operate/troubleshoot machine on its own. Not sure if you have to switch some key on the back to change the mode, or it will initialize on its own using the last program that has been loaded....it's been awhile. Line computer dow
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Mon Mar 09 16:22:05 EDT 2020 | sportsradar
Hello Kristof, We use 1 PC which does line control and programming. We always boot the PC up first, then when it is fully booted, then we turn the machine on, we let it zero set, then we send the job over (this is how we do it when everything works)
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
1 |