Electronics Forum | Fri Apr 26 12:39:05 EDT 2013 | mmjm_1099
First started with having to replace the power supply in the computer. Once we did this now I am getting a "power failure detected" error on the screen as an alarm for the oven program. Anyone have some advice or input on this?
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Fri Jan 12 09:22:51 EST 2018 | dskling
Hello We have a Vitronics XPM820 that has us stumped. We have replaced both power supplies (G1 and G2) and we still cannot clear this alarm. The A1 board has all 4 leds light for proper voltages. We have verified that we are getting the correct vo
Electronics Forum | Fri Aug 26 01:46:04 EDT 2022 | angela t
The drive and power supply were checked and were fine, but later I found that there was a problem with the J22 cable, which would alarm if I touched it. I suspected that the cable was damaged and planned to buy a replacement cable to try.
Electronics Forum | Wed Nov 03 14:44:45 EDT 2010 | aj
have you checked your power supplies are all giving correct outputs?
Electronics Forum | Thu Nov 04 02:14:19 EDT 2010 | adriana
Yes, we are checked all power supplies and is OK! Many thanks!
Electronics Forum | Fri Feb 16 04:15:57 EST 2018 | sachinverma
hi , please check the main S/w. of the Reflow machine.
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Fri Oct 27 03:02:54 EDT 2017 | praveenmuthusamy
Dear All, what might be the reasons for servo alarm on W axis in YXI(X RAY INSPECTION MACHINE)?? MAKER: YAMAHA TYPE: KLC-0000 NOTE:MACHINE CANNOT BE RESET UNLESS POWER SHUTDOWN. MACHINE RETURNS TO NORMAL STATE ONCE POWER SHUTDOWN AND RESATARTED! R