Electronics Forum | Mon Oct 05 13:15:05 EDT 2020 | proceng1
I am trying to replace the anti-backlash nuts for the moveable rail on my ACCUFLEX Printer. I have parts diagrams, but none show the Y-axis width lead screw assembly. I can't figure out how to disassemble the screws to get the nuts out. Does som
Electronics Forum | Tue Oct 06 11:43:23 EDT 2020 | proceng1
Thank you Phil. You certainly had two documents that I did not have. I have downloaded them and I will go through to see if I can find what I need.
Electronics Forum | Tue Oct 06 11:21:26 EDT 2020 | dontfeedphils
I'm not sure if any of the docs I have contain the info you're looking for, but here's what I've got. https://drive.google.com/drive/folders/1ZD2gMsvIu8QB9Ikj5LZivoO2RpwlYEN-?usp=sharing
Electronics Forum | Mon Apr 15 11:09:16 EDT 2024 | oxygensmd
On of connector not seat properly. On your photo (114844) it seems to be an D-Sub connector, on the left side. If you are there, you can disconnect and measure the is something (voltage, signal, etc) using your schametic drawing to find out what it w
Electronics Forum | Mon Feb 12 08:37:04 EST 2018 | dontfeedphils
The piece that splits the vision probably has smudges or scratches on it. You're able to teach a set of pads. Before teaching the fid, hit the "Draw Correlation Box" button (I think that's what it's called, it's been a couple years). Then draw a b
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
| 1 |
.gif)
