Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Tue Feb 01 18:50:39 EST 2022 | proceng1
Did you get this figured out? I just took two Accuflexs out of service and I still have one in service. Tell me more about the issue. I may also have parts if you need anything.
Electronics Forum | Thu Jan 13 19:39:57 EST 2022 | openindus
Nobody have any answer on this issue? We are really strugling with that since begining of this year.
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Wed Feb 02 08:12:58 EST 2022 | openindus
And the offer for spare parts is much appreciated. We have the nuts on the automatic conveyor systems that seems to be a little of tolerance. I will get back to you if we can't fix that with new parts.
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Fri Mar 26 06:58:06 EDT 2010 | ristikas
Hello, We have here very oftenly one error in our MPM Accuflex. I dont know who to ask about that errors... The error is „The transfer light peam interlock has been broken. Remove the obstacle from the path of the beam.“ I checked the sensors and
