Electronics Forum | Fri Mar 01 13:35:41 EST 2024 | proceng1
Message me. I know a few of the former Service Techs from ACE, depending on your location, they may be available for side-work.
Electronics Forum | Wed Mar 28 08:45:03 EDT 2007 | pjc
I have seen point-to-point soldering iron tip robots in action at a number of factories. The problem is repeatability at delivering good solder joints. Consider a small selective solder machine, the nozzle type: www.ace-protech.com www.air-vac-eng.c
Electronics Forum | Wed Mar 10 00:21:34 EST 2010 | geocep
I have recently purchased an ACE Kiss 101A Selective Solder System 4 weeks ago. I am having a terrible experience. The nozzle will not stay wet, and the flux-er pattern continues to shift erratically; all leading to very poor quality process. ACE
Electronics Forum | Thu May 20 17:51:28 EDT 2010 | geocep
ACE sent an engineer from the Factory, and now the process is running much better. We had lots of problems, but in the end ACE never gave up, stood behind their product, and kept supporting until we got the process to work. We are now able to consi
Electronics Forum | Thu Mar 11 11:08:22 EST 2010 | geocep
I am using AIM Electropure SN63/Pb37 Solder, & AIM NC266-3 Flux; just like what ACE recommends. I have both Ultra High Pure T-Tanks and a Cryogenic Dewar Tank for Nitrogen, and neither seems to have improved the problem. I place a piece of tempered
Electronics Forum | Fri May 18 13:50:38 EDT 2007 | realchunks
Hi Grant, Replacing a wave witha spot solder? You must have very few comonents to solder or all day to solder them. Why are thinking of doing this? Well, I have looked at just about every selective machine out there. What it all boils down to is
Electronics Forum | Mon Apr 23 10:11:11 EDT 2007 | grayman
Glue application is widely used in my country.However, some companies want to save cost and remove the glue application. We are also using fixture to cover some components. It has no problem. Please try cleaning your fixture by alcohol or water.Brush
| 1 |
.gif)
