Electronics Forum | Thu Aug 26 12:55:44 EDT 2010 | fuji
My spec book shows 10 NL/min
Electronics Forum | Thu Aug 26 09:44:45 EDT 2010 | smtmfgeng
Hello all, I have a few CP43's and am struggling to find their air consumption ratings. I found that our IP3 consumes 240 Nl/min for the machine itself, and the MTU unit consumes 600 Nl/min, however Fuji's spec sheets do not list these ratings for t
Electronics Forum | Tue Aug 25 11:31:41 EDT 2020 | stephendo
yes Once I was using dewers of liquid N2 and recommended switching. I tried using air to the machine so the sensor would let the machine run. Boards went from good to a two inch icicle covering a large area. We went to a wall mounted single stage fi
Electronics Forum | Tue May 09 02:18:45 EDT 2006 | Helmi
Hi, My company is using HEPA filter to improve air quality coming out of oven/wave solder. But the cost of such filter is quite high and we need to improve the consumption. Any suggestion from fellow experts out there? a. Anybody did a cost reduc
Electronics Forum | Thu Apr 24 12:45:41 EDT 2003 | cyber_wolf
Can someone possibly post a link, or get me the specs/requirements of an Omniflow 10 reflow oven ? Air consumption, power consumption, dimensions etc... Thanks
Electronics Forum | Tue Sep 23 13:00:28 EDT 2008 | mikesewell
I installed an On Site unit for our SS machine. You'll need to size it in terms of flow rate to your equipment (possibly put a reservoir tank in) and decide on what purity level is required. Maintenance was very minimal. Just remember to factor it
Electronics Forum | Mon Dec 18 14:11:02 EST 2023 | erikfriesen
Has anyone ever replaced the venturi vaccum pump on the CP45 or other series machine? Or used a centralized vaccum system? It works fine, but air consumption seems excessive. This is what is in there, it probably uses 10cfm at least. https://www.p
Electronics Forum | Tue Jul 09 15:40:06 EDT 2019 | assuredtech
That's a great point about air consumption, don't reduce the 1/2 inch air line requirement, meet the CFM air requirement and of course dry shop air. Check the Auto oiler for the CTA is running correctly, 5W 30 NON Detergent oil only. Attached is a pi
Electronics Forum | Mon Jun 25 19:53:57 EDT 2007 | vlazern
Our Hellers exhaust has a range from 500 to 600 CFM, depending on model. I am aware that the profile will need adjustment due after reducing the exhaust air velocity, but i'm not getting a reply from Heller for power consumption specification. I will
Electronics Forum | Thu May 21 06:15:46 EDT 2020 | bukas
everything Stephen said + it is really important that you have correct diameter pipes. If diameter is too small there will be a significant pressure drop in pipes (and machines have their consumption 100-500 NL - normal liters / min) and pipe system