Electronics Forum | Mon Sep 28 10:12:53 EDT 1998 | Chrys
| Hello, | I need some users information about "Air knif" in wave soldering: | 1. Does it decreases bridging ? | 2. Is it self installed of a purchesed kit (if purchesed, who are the recomended vendors) ? | 3. Any other information about the issue. |
Electronics Forum | Fri Mar 11 03:23:58 EST 2005 | py (france)
ken, in order to improve the wettability I suppose.... But it seems that jimk wants N2 for the reflow owen even if he does not need N2... ==== jimk: see air-liquide, linde gaz, and praxair , you can by N2 liquid in tank , or any other conditionnemen
Electronics Forum | Wed Jul 28 11:47:16 EDT 2004 | GCronin
I am looking for a consistent method of applying no clean liquid flux to solder pads. My main concern is if I use a standard air-over type dispenser mounted to an automated arm that the liquid flux will make a mess and not be consistent. I'm not to
Electronics Forum | Fri Feb 14 22:03:40 EST 2003 | caldon
Air liquide has some great articles on this www.airliquide.com Cal
Electronics Forum | Fri Nov 05 21:29:56 EST 1999 | chartrain
No matter what type container you use, air in the delivery line will always be a problem. When you pop the lid on a pressurized container, fill it with a liquid and reseal it, air will be present over the liquid. Where do you think it goes?It has to
Electronics Forum | Wed Aug 31 14:45:35 EDT 2011 | ryanr
Non-Hermetically sealed parts are parts are not air tight and gasses and liquids will pass into the package of the part and come in contact with the electrical or other components within the package (i.e. some switches, relays, transformers, etc.) D
Electronics Forum | Tue Dec 28 12:59:34 EST 1999 | Justin Medernach
Edmund, Check your "Air Amp" settings or the equivalent on your oven. Sounds to me like they are probably turned up too high in the reflow zone and you are blowing the components off of the board when the solder goes liquidous. Regards, Justin
Electronics Forum | Mon Feb 18 22:18:06 EST 2002 | mantis
Yep i agree most likely misplacment or reflow, maybe check your air flow around the liquidous zones(if convection oven) probably too low.
Electronics Forum | Fri Apr 04 10:02:20 EST 2003 | rdr
Do you reflow both sides of the boards before washing? Sometimes these white residues occur from "burnt" flux. we see this from time to time especially when using hot air and liquid flux. Russ
Electronics Forum | Wed Apr 07 14:12:53 EDT 2004 | Paul
The easiest way to remove air bubbles from any fluid is to place it into a vacuum chamber. I do this almost daily with liquid rubber coatings, glues, and plastics.