Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Thu Apr 11 21:20:04 EDT 2013 | dman97
Hello. I am having a problem with a CP3 machine. This machine decides every so often to kill 24v power to its self. At first I thought it was a bad 24V power supply, but I swapped it out and it still decides to occasionally kill its self. I also re
Electronics Forum | Wed Apr 24 15:38:02 EDT 2013 | dilogic
Check the fuses on the power distribution panel. All of them have indicating LED, so check is easy. Maybe 24V feeder supply is out...
Electronics Forum | Thu Feb 06 14:01:55 EST 2014 | rgduval
1. Fuse 2. Power Supply 3. Power Distribution card 4. Booster Start by checking all of the fuses on the front of the power supply (accessed by removing the front cover of the machine). Then, check all of the fuses on the first card in the MOT bay.
Electronics Forum | Wed Dec 23 12:57:59 EST 2020 | ilavu
Check Power Distribution Panel Power Supply. No output or output too low for 24V, 15V, and 12V. Also, LED's on PDP LT6, LT7, LT8 , LT9, LT10, LT11 don't turn on at all, even though all fuses test OK for continuity.
Electronics Forum | Thu Jun 08 17:39:28 EDT 2017 | zsoden
SuMoTe, that is a fair suggestion, but I believe will be a non-starter. The solder pump motors are actually 40V motors being run from a PWM 24V supply. I did one time try hooking up to a separate power supply up to 40V but all this seemed to do was m
Electronics Forum | Thu Oct 22 05:36:58 EDT 2015 | myleb
Hi Nhel, It's quite strange problem here... 1. The voltage check: please supply power voltage. Inside machine (BF) there is a transformer, please make sure the voltage setup is correct. 2. In Ringload information, please see the 12V and 24V, is it
Electronics Forum | Thu Aug 04 14:01:56 EDT 2022 | ttheis
We are having an issue with a Jade S200 we recently purchased. When opening the pillarcom software it is unable to establish communication with the machine. The power supplies and fuses all seem to be ok and at proper voltages. Checked as many connec
winsouce.jpg)
