Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Fri Aug 03 17:00:57 EDT 2001 | mparker
Start with a definition of what you expect the AOI to achieve at each station. Will your in-line machine be post print? Place (pre-reflow) or post reflow? Rather than buy one very expensive machine to put at the end of the line, maybe a couple of
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Sun Aug 09 15:25:17 EDT 2015 | dev88
dear sir i am new for aoi section,my work will be teaching of aoi defect and related to programming, want to know how to make program easily in mirtec 4.1.1 and what are the different standard which we must understand.
Electronics Forum | Wed Oct 09 13:52:17 EDT 2019 | valletta
Hi Aurther, Thanks for a prompt reply. I agree but unfortunately our AOI is 2D and misses a lot of solder defects especially on connector terminals which are surface mount. We are also dependent on operator at AOI to mark the defect if caught by AOI
Electronics Forum | Mon May 07 09:40:16 EDT 2001 | bphilips
What defects can not be found or are very difficult to find with 2D AOI?
Electronics Forum | Thu Aug 07 22:56:50 EDT 2008 | dlocampo
First all, you must define the specific defects that you wanted to screen out by your AOI system based on its capability, so you can allocate the undetected defects on your other means of inspection methodology. Then optimize your AOI inspection para
Electronics Forum | Wed Apr 19 04:38:49 EDT 2006 | ge_lim
Hi Refering to the Apr edition of SMT , page 24 to 29, anyone got experience on implementing the AOI or 3D x ray : a) What is the pros and cons? b) What is the trend in the PCBA industry for wave soldering inspection? c) Will this implementation co
Electronics Forum | Mon Apr 24 15:11:11 EDT 2006 | pjc
For solder joint inspection you cannot beat AXI. That's what is was designed for. AOI machines were designed for component inspections and solder joint checking was an add-on. In transmission AXI you can get a measurement of the whole solder joint. A
Electronics Forum | Tue Dec 15 02:00:32 EST 2015 | padawanlinuxero
We do what here is call a master, this board has a bunch of misalign components, missing components, bad solder joints, crack components, and other defects that we want the AOI to look for, now we compare what the AOI finds with a list of the defects
winsouce.jpg)
.gif)
