Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Thu Dec 01 14:47:25 EST 2005 | Amol Kane
Hi, I am testing some lead-free assemblies using ATC. it was suggested to me that if i do in-situ testing, then i should measure the starting resistance, and subsequent resistances values after n cycles, and when the resistance value increases by 1 o
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Fri Dec 15 07:37:07 EST 2006 | realchunks
Try changing blades. If still a problem, move job to another printer and cross feed to your existing line. If all else fails, try buying a new stencil. You could get new by Monday.
Electronics Forum | Thu Aug 14 03:54:59 EDT 2014 | ermani9
Failing to origin the machine. On pressing ORIGIN, it moves a small distance and gives the message "ORIGIN INCOMPLETE" and displays error ...243:Y DRIFT ADJUSTMENT NO GOOD..." Please help.
Electronics Forum | Sun Sep 18 06:17:40 EDT 2022 | poly
I'll double check tomorrow but I don't think so, it fails zeroing straight away (without moving the other parts) when the PWC axis is enabled, which is why I tried swapping the board as I assumed it was a controller not being found issue.
Electronics Forum | Tue Jan 24 16:35:16 EST 2017 | siltron
Hi everyone, We bought a used Juki KE a few months ago. Installed it at the beginning of this year, but have some problems with the Z and ROT servos. As soon as the machine is powered on, the ALM04 red led turns on on some of the Z and ROT drivers.
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of