Electronics Forum | Wed Apr 21 18:24:13 EDT 2004 | pjohnson@volterra.com
Simple process - we use similar Kester solder brands of "no clean" low residue solder wick to clean our pads, then brush with isopropyl, and apply Kesters brand of tacky flux under a Leica 6x microscope. We do this on 7x7mm and 9x9mm packages. This w
Electronics Forum | Tue May 09 14:56:43 EDT 2006 | JW
An option to consider is leave top and bottom heaters settings the same; to get correct liquidus time and temperature on one side, you will have some amount of reflow on the second side. If you have BGA's, QFP's on the bottom side yet they are smalle
Electronics Forum | Mon Sep 27 15:57:21 EDT 2010 | mikesewell
I've owned two PDR Lightmaster IR rework stations (bought at 2 diff. companies) and have been extremely happy with them. Closed loop,separate control of top and bottom heater via non contact thermocouples. Control the process, not the product - set
Electronics Forum | Wed Dec 22 14:21:13 EST 2004 | James Dornan of APE Inc
A little late but if this subject is still of interest the following paper from APE may be of interestwhen considering IR to Air Bath: HOT AIR versus IR and other convection Rework Systems HOT AIR is the most popularly chosen method of rework in th
Electronics Forum | Mon Oct 14 12:56:50 EDT 2002 | davef
His technical contribution to the forum. From these 24 postings, we can see that 75% of Sean�s postings have a decided commercial bent, as followings: * Could be argued that the posting is a good technical response. Percent of postings 25%. * Could
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
| 1 |
