Electronics Forum | Mon Aug 20 09:49:57 EDT 2018 | dontfeedphils
Not entirely clear on your question. We don't coat any of our hardware (assemblies are coated prior to hardware installation), so if coating needs to be reworked after this, then hardware removal is needed.
Electronics Forum | Sat Aug 18 10:35:41 EDT 2018 | mgerrior
Hey Phil, i'm just curious what your rework processes are for your hardware after conformal coating is applied (if any). I'm interested in conformal coating as our hardware can be exposed to moisture rich environments at customer sites but to my kno
Electronics Forum | Tue Jul 03 01:54:42 EDT 2018 | rdhiman1
Reaching out to all conformal coating experts, please help! While setting up conformal coating using the automated atomized spray, we observing issues associated with conformal coating wetting on the following regions: 1) Component edges 2) Metalli
Electronics Forum | Tue Aug 14 16:18:48 EDT 2018 | dontfeedphils
A couple of things to try as I just went through this myself. Checkout this link for pointers on plasma cleaning... http://www.nordson.com/~/media/Files/Nordson/march/Papers/The-Effects-of-Plasma-Treatment-Prior-to-Conformal-Coating-NordsonMARCH.p
Electronics Forum | Fri Oct 29 17:44:13 EDT 2004 | davidcb
Davef, thanks for inputs. I think your correct, we have since obtained some ionic analysis and sure enough there is relatively high chlorides on the bare pcbs. The toluene is controlled within dip tank / drying system, almost no exposure to workers.
Electronics Forum | Mon Dec 21 11:31:19 EST 2009 | lynn_norman
Fusion makes UV ovens. Most conformal coating suppliers have a UV line. Great for quick cures, but the ovens interfered with our automated guided vehicles, so we had to abandon the UV.
Electronics Forum | Wed Nov 25 15:16:04 EST 2009 | sforman1
Why in heavens name are you using a heat or air cure conformal coating. Why aren't you using a 100% solids UV cure system. You would never have an issue like this Sam Forman MicroCoat Technologies
Electronics Forum | Fri Feb 24 07:28:11 EST 2012 | duso02
If you are going to coat very low volumes then just spray it by hand. The automated machines just won't be worth it unless you are going to do a very large run. They are complicated, require constant attention, still require masking the board and are
Electronics Forum | Wed Jun 03 07:13:27 EDT 1998 | Tom Tellinghuisen
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Wed Jun 03 15:22:12 EDT 1998 | Greg Curler
| | We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not