Electronics Forum: ax 5 axis errors (Page 1 of 4)

contact 3av head homing errors

Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt

I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.

Skew error at axis G1F-Y

Electronics Forum | Thu Nov 03 01:39:53 EDT 2022 | spacecase

Thank you for the response, left the machine turned off for a good period of time and somehow the issue solved itself. I was able to calibrate the next day and homing hasn't been an issue. However now I'm having another problem where it gets 4 comple

DEK 265 motor com error, axis 1,2,3 fatal error

Electronics Forum | Thu Sep 01 09:08:04 EDT 2016 | dekhead

Yes, wired correctly (5, 12, -12) can easily run on a standard 300W computer PSU.

DEK 265 motor com error, axis 1,2,3 fatal error

Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas

hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s

DEK 265 motor com error, axis 1,2,3 fatal error

Electronics Forum | Thu Sep 01 08:30:54 EDT 2016 | bukas

Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > www.dekhead.com > Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > http:/

Fuji CP6-5 Servo Z overflow?

Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell

problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob

XP142E R AXIS Servo Error

Electronics Forum | Wed Aug 26 04:31:20 EDT 2009 | prasadz

In XP142E very often we are exprencing the R Axis Servo error. When we reduce the Speed to 0.5 it becomes OK. Any body can give solution for this.

Juki KE750 Axis Error (E200078)

Electronics Forum | Sat Aug 26 21:53:47 EDT 2017 | kieren

Hi Everyone. I am looking for some help with my Juki Ke750. The problem is that after booting up and then starting the home position function I receive an error as stated below Message File Error E0000: KEY=200078 STATUS=2 C:¥X750 ¥GX3ERROR。MSG

MPM Ultrapint series 2000

Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris

Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin

ASG BMEP-5T Press

Electronics Forum | Tue Sep 23 14:23:19 EDT 2008 | jeffjarmato

Exact Error Message: Following error on Z axis Happens during Homing the machine. Right now as Z Up

  1 2 3 4 Next

ax 5 axis errors searches for Companies, Equipment, Machines, Suppliers & Information