Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Fri Jan 27 16:42:29 EST 2023 | dilogic
We have odd problem with zeroing of UIC Advantis (4982B). It performs axis zeroing without complaining (all axes enabled at the end), but after final move of the head to the center of the machine, it hangs without any error message. Status isshowing
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Mon Oct 20 10:08:42 EDT 2014 | rgduval
Had someone in from the broker that we bought this machine from, and he did some poking around. We've learned some things, but, unfortunately, are still no closer to getting the machine running :( We discovered (based on double checking other machi