Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Wed Jan 02 10:20:10 EST 2019 | jdengler
Sorry, I looked at an IP-3 not 2. It looks like for the IP2 they bundle the MTU and machine proper together so it should be sending the data when you transmit the one file. Do the axis travel in the correct direction? If yes the only thing I can
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Wed Jun 23 13:08:09 EDT 1999 | Dave F
| | Cunli: Chrys is not the only one. Check the following: | | | | "Lead Free Solders - A push in the wrong direction?" | | Dave, | | Thank you for letting me know. We will get in touch with the contributor right away to correct the entry. Loo
Electronics Forum | Tue Sep 23 17:52:12 EDT 2003 | lysik
I work for a large Contract manufacturer. We use Fuji Siemens and Universal. Universal is by far the most stable reliable system. They always have the parts in stock we need. Great support. Samsung has now pulled out of direct sales in the US. I woul
Electronics Forum | Tue Jun 22 16:17:20 EDT 1999 | Cunli
| Cunli: Chrys is not the only one. Check the following: | | "Lead Free Solders - A push in the wrong direction?" Dave, Thank you for letting me know. We will get in touch with the contributor right away to correct the entry. Looks like Chrys
Electronics Forum | Tue Aug 28 11:40:03 EDT 2007 | lloyd
As in the previous reply, When the machine is powered up don't press the start button. Just wait until the software has loaded then go into Sitest (you may need to logon as SERVICE). In the gantry or head menu's you should find the nozzle configurat
Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
winsouce.jpg)
