Electronics Forum | Wed May 17 17:13:47 EDT 2000 | Michael Parker
The MoonMan has spoken. Everybody get back up on the wall, its been long enough that this has been "off the wall". Wish I had more Rambus chips, just got my SMT process dialed in and ran out of stock. Damn.
Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Mon Jun 15 19:51:48 EDT 1998 | Earl Moon
I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. Deeply invloved in micro BGA, CBGA,
Electronics Forum | Fri Feb 22 13:19:54 EST 2013 | caurbach
Our new Soltec Delta 3 has this feature (they call it mainwave pushup) where you can add up to 60 rpm to the pump after the leading edge passes over the wave. Unfortunately, our old Delta Wave doesn't have this feature. Ideally we'd like to set it
Electronics Forum | Tue Jun 16 15:39:43 EDT 1998 | Steve Gregory
| | I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | | Deeply invloved in micro BG
Electronics Forum | Tue Jun 16 14:10:11 EDT 1998 | Wayne
| I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | Deeply invloved in micro BGA, C
Electronics Forum | Tue Jun 16 09:03:57 EDT 1998 | Justin Medernach
| I'm off (as you all know) to other pastures. You know - sheep tupping on the green (or some other Elizabethan BS). Anyway, I now have to go to work for a living, or retire (don't remember which), to make a living. | Deeply invloved in micro BGA, C
Electronics Forum | Wed Jun 17 07:12:45 EDT 1998 | wayne
| Hey Wayne! | Just 'cause I experimented with way too much LSD in the 60's, huff Toulene and airplane glue on a daily basis, and mainline prozac in my jugular, don't mean I'm slow...I'm just r-e-l-a-x-e-d. | (GRIN) | I think I figured it
Electronics Forum | Tue Jun 16 07:26:07 EDT 1998 | Sherry
Going, going, gone, but back? It must be early, this post is quite confusing, ok I'm having a blonde moment. Sounds like you're going to be quite busy, I wish you well! Also, wanted to let you know...my email has been down Once they get it operatio
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
.gif)
