Electronics Forum | Wed Aug 21 07:24:12 EDT 2002 | bayanbaru
What is the correct method to bake or cure the component?Standard baking practise by us is to place the units into oven at 125 �C for 8 hrs directly. But I was told that the correct baking practise is to cool down the Baking Oven to Room temp and onl
Electronics Forum | Mon Sep 20 16:06:53 EDT 2004 | blnorman
We require that the ovens used for bake out are vented, thus removing the vapor from the oven.
Electronics Forum | Wed Sep 15 17:53:53 EDT 2004 | aaronrobinson
My question is how does heat alone (125DegC for 48hours) diffuse the water vapour in a component, I figure the amount of water vapour in grams per cubic cm will be the same regardless of temp...yes with temp the RH changes but once the component rea
Electronics Forum | Wed Feb 15 04:25:56 EST 2006 | der
one of the guys was baking a 672BGA . he mistakenly left the oven on over night so instead of baking for 12 hours at 125 degrees C, they got baked for 24 hours. Is there any detrimental impact on the BGAs or are they just well baked???
Electronics Forum | Tue Jul 16 01:12:31 EDT 2002 | ppcbs
We find that baking PCB assemblies at 90 degrees C in a Blue M forced air oven is safe for most all PCB's that we have encountered over the past 12 years. We remove any external plactic hardware that may be attached to the assembly and also like to
Electronics Forum | Sun Sep 19 19:51:31 EDT 2004 | aaronrobinson
thanks for your reply ....yes the air is then able to hold more water vapour.... but so is the component hence there is no water vapour pressure difference and the component and the air in the oven would still be in equilibrium???? hence no effective
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Fri Nov 22 10:38:30 EST 2002 | slthomas
The follwing is from the Technet archives, per IPC's Jack Crawford. I dug it up during some investigation of a supplier's issues with humidity in an Asian plant: There is support for this in IPD-HDBK-001 w/Amendment 1 Handbook and Guide to Suppleme
Electronics Forum | Thu Nov 01 00:32:14 EST 2001 | ianchan
we bake boards 80~120 deg-C @1hr, after in-line DI wash. oven setting to 90 deg-C, as +/-5 deg-C, tolerance against door open/shut fluctuations = "temperature loss". If anyone has evidenced procedure, that shows no need for baking, pray do share wi
Electronics Forum | Sat Aug 25 08:39:15 EDT 2007 | gsala
If plastic Carrier Tape (CT)/ emboss tape, is made by: a)Polycarbonate material, it can withstand temperature around 120C� or may be more mantaining original dimension. b)Polystirene material, at max 45�C-50C� the CT starts to change dimensions and
