Electronics Forum | Wed Feb 28 14:25:33 EST 2007 | Bill
We have a board that uses a solder pad for one of the contacts of a button battery and had no problems when we were washing the boards. We are now using a no-clean flux and find that on a bunch of boards there is a coating of flux covering the pad s
Electronics Forum | Wed Feb 28 15:09:57 EST 2007 | Hussman
Some no-cleans will pool flux on the top of the solder joint which acts like an insulator. I normally do not paste "contact" pads. You can have your board house HASL them if you need the extra bump on the pad.
Electronics Forum | Tue Apr 22 08:55:54 EDT 2014 | davef
I assume that you're talking about wanting to solder to metal tabs that are spot welded to the battery terminal. These tabs are not meant to be soldered. The metal was special selected for welding. In the old days, you could buy plumbing flux at th
Electronics Forum | Thu Aug 16 04:35:10 EDT 2012 | craigweir
Can anyone advise on the risks involved in using a (previously soldered) component, in this case an 'SOIC8', as pick-up area for subsequent pick/place operation of sub-assy to larger motherboard ? The sub-assy in question would be a small outline(25
Electronics Forum | Fri Apr 25 14:49:34 EDT 2014 | isd_jwendell
If the tab is Sn plated, you can solder to it as long as your iron has enough power (watts). If you continue to have trouble then it probably isn't Sn plated.
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Tue Apr 22 12:33:35 EDT 2014 | barryg
No we have a battery spring that is soldered directly to a PCB (standard tin plated copper PCB). The Battery spring supplier (and I have no confirmation he makes them or buys them) claims they are tin plated. When trying to solder to them it is very
Electronics Forum | Mon Apr 21 16:38:45 EDT 2014 | barryg
Hello all. We have been having some problems soldering to what we believe is a nickel plated spring steel battery terminal to a PCB. We have tried scrapping , then tinning, dipping and still have problems. Are there any special fluxes or pre-treats t
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Fri Oct 17 06:44:32 EDT 2014 | hemant_pang23
We are doing hand soldering for the 'BATTERY LITHIUM COIN CELL 3V CR 2032 but now we want do the soldering through wave soldering process ,for avoiding the shortckt only one pin will get solder through wave process and other pin will be soldered manu