Electronics Forum | Wed Feb 05 11:31:40 EST 2003 | lloyd
The grease to use is DAPHNE EPONEX M No. 1 as you would expect it is made by an oriental company (IDEMITSU KOSAN). Sanyo recommend that this procedure should only be carried out by trained personnel, so it may be worth giving them a ring before you s
Electronics Forum | Fri Feb 14 17:25:17 EST 2003 | mikeo
Hello, As an Ex-Sanyo engineer I agree with the previous reply. Use EP1 sparingly. You may find that the nozzle sleeves are scored when you remove them. This is from lack of cleaning. You can only buy the sleeve and bearing from sanyo which is a was
Electronics Forum | Wed Dec 15 01:25:14 EST 1999 | Bubba
Larry, What has been removed from the machine lately. Most bearings don't just fall apart while running without giving some type of warning. My experiance with LM bearings is they usually don't just fall out, most cases the bearing block was removed
Electronics Forum | Tue Apr 09 22:32:05 EDT 2013 | jeffr
There is no easy way... but this is how I do it.. Origin the R axis, losen the idler bearings on the belt, remove the C clips at the top of the heads, lift up and remove the spindle assemblies being careful not to lose the 2 balls in the side of the
Electronics Forum | Fri Mar 06 02:25:08 EST 2020 | bukas
it is not that big deal. you can use almost any generic grease. I use SKF bearing grease on CP45FV's. Just make sure you remove old grease, I use IPA and compressed air to do this. And don't put too much of it or too little. After greasing everything
Electronics Forum | Wed Jun 24 08:19:59 EDT 2009 | fujiphil
Hi, Procedure how to replace the x-ballscrew of CP642. 1. Before you remove the x-motor, remember the pulse of x-axis motor just it turn ON the zero set sensor. Pulse usually at 1000pls. +/-50pls. 2. Turn Off the machine. 3. Compress the two ballsc
Electronics Forum | Wed Feb 03 20:26:49 EST 2010 | mika
Hi, First: 1. What os/system? 2. what s/w version? 3. what type of machine model? 4. What type of head configuration? 5. Do you have this head front or back? 6. Do you have encounter this problem before? 7. Have you recently placed any new "high com
Electronics Forum | Tue Sep 15 14:11:59 EDT 2015 | jpal
You should also remove all the pump parts and clean them, checking the bearings and seals. Clean completely the parts that allow the solder to flow back into the pot; ours have a spiral that fills with dross. Treat yourself to new nozzles. Tinning
Electronics Forum | Wed Mar 02 04:32:07 EST 2005 | Hannu
Hi all We have an Omniflo 5 (-97 vintage) with pin chain conveyor. Lately the chain drive motor has started to emit some chirping noises, as if there were a bearing running dry or something. Is there some kind of maintenance schedule specified for t
Electronics Forum | Wed Mar 17 10:12:16 EDT 2010 | dj_jago
Is it the pressurized system or the pump system you have fitted to the machine? Are you getting an error message 'No flow nozzle 1'? Check the 'ShoRate' gauge at the back of the machine and make sure the ball bearing rises in the glass tube when you
.png)
