Electronics Forum | Wed Feb 08 03:24:00 EST 2017 | soldertraining
Tin dipping of components in RoHS compatible solder is one means to turn the lead bearing components in to devices which can be used in a RoHS compatible soldering process. The conversion of lead bearing components into those which can be used in the
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Sep 19 22:45:19 EDT 2006 | darby
Larry, The Quad is based on the Samsung - yes? If so, here are the final recommended answers from Samsung. All LM guides and bearings, ball splines and rack and pinion use Shell Alvania EP2. Sometimes called LF2. Sometimes called Albania. It's a dar
Electronics Forum | Fri Feb 14 17:25:17 EST 2003 | mikeo
Hello, As an Ex-Sanyo engineer I agree with the previous reply. Use EP1 sparingly. You may find that the nozzle sleeves are scored when you remove them. This is from lack of cleaning. You can only buy the sleeve and bearing from sanyo which is a was
Electronics Forum | Thu Aug 24 16:59:11 EDT 2000 | Dr. Ning-Cheng Lee
For reflowed solder joints, Bi bearing solder has been reported to exhibit superior fatigue resistance. It also provides better wetting than many other alternatives, including SnAgCu systems. In my opinion, it may be the choice once all Pb can be pha
Electronics Forum | Wed Feb 05 11:31:40 EST 2003 | lloyd
The grease to use is DAPHNE EPONEX M No. 1 as you would expect it is made by an oriental company (IDEMITSU KOSAN). Sanyo recommend that this procedure should only be carried out by trained personnel, so it may be worth giving them a ring before you s
Electronics Forum | Wed Mar 02 04:32:07 EST 2005 | Hannu
Hi all We have an Omniflo 5 (-97 vintage) with pin chain conveyor. Lately the chain drive motor has started to emit some chirping noises, as if there were a bearing running dry or something. Is there some kind of maintenance schedule specified for t
Electronics Forum | Wed Mar 16 17:43:33 EST 2005 | pmd
We grease acording to PM schedule. The cable is very old about 5 years. We run 2 shifts. The transducer program and burnin test show the varance that we are seeing phisically so I can rule out the transducer. The motor may be the cause as it is of 19
Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
