Electronics Forum | Sat Apr 25 19:40:01 EDT 1998 | Stan Traxler
| We have to mount our SMD devices 0.1 to 0.4 mm off the pcb | PCb substrate to compensate for thermal stressing in a | Space enviroment. Has any one any ideas or contacts for | dissolvable pads. this only applies to leadless components We have appl
Electronics Forum | Wed Nov 12 04:34:17 EST 2008 | kywl
Hi all, Assuming that i were to design a PCB and there are multiple components, what is the minimum spacing required to ensure that i won't have problems in my SMT process later on? Also, is there a minimum component stand-off height spec as well?
Electronics Forum | Thu Nov 13 22:20:48 EST 2008 | davef
For your pad layout and spacing between components, look here: http://portal.ipc.org/Purchase/ProductDetail.aspx?Product_code=77b562c1-b8f8-db11-8a6a-005056875b22 For your standoff height in SMT, we do not concern ourselves with standoff height. It
Electronics Forum | Fri Nov 14 03:41:26 EST 2008 | kywl
For your pad layout and spacing between > components, look here: _a class=roll > href="http://portal.ipc.org/Purchase/ProductDetail > .aspx?Product_code=77b562c1-b8f8-db11-8a6a-0050568 > 75b22" > target="_blank"_http://portal.ipc.org/Purchase/Pr
Electronics Forum | Fri Nov 14 07:32:24 EST 2008 | davef
Yes, courtyard gives you the space requirement of a component. Sometimes, the working space of a rework tool takes precidence, though.
Electronics Forum | Mon Jul 06 18:00:16 EDT 2015 | jwqc
Does any one know how to calculate BGA height change after reflow oven? I guess the calculation will be based on the component size, weight, ball diameter and ball count of the BGA, but how to get the actual height?
Electronics Forum | Tue Jul 07 10:25:03 EDT 2015 | swag
Dial indicator on a post/base. You might need a fine point tip to get between adjascent components and the BGA. Or... if you're real fance schmancy you could use a CMM if you have one.
Electronics Forum | Mon May 07 16:07:05 EDT 2012 | davef
Start with targets based on the stencil thickness (for height) and stencil thickness times the aperture size (for volume). * Set reasonable upper and lower control limits (+ 25% and –25 % of the targets, for example). * Next, check the printer set-u
Electronics Forum | Fri Feb 20 08:56:42 EST 2004 | davef
We successfully clean WS flux on 1mm and 1.25mm pitch BGA. For 0.8mm pitch BGA, we use no clean, because we cannot remove the flux residue from under them efficiently. Use ion chromatography testing to be sure it is clean under the BGA. IC is the on
Electronics Forum | Tue Aug 21 08:44:48 EDT 2001 | caldon
A) The standoff height of some uBGA components does not allow water to penatrate under the component. B)Water soluable may dilute the flux and not remove it all together. This can be tested with Ion Chromatography. C) Water soluable in some cases ne