Electronics Forum | Sat Dec 29 01:28:48 EST 2018 | emmamillathompson
We are using a smps for our comm pcb , a relay and a current sensor, which uses 4.2v, 12v and 5v respectively. We are controling one phase of a three phase 5hp water motor. Also smps circuit and relay output are in parallel so output load doesnt effe
Electronics Forum | Sun Jun 05 00:00:17 EDT 2022 | curtisp
We are having a problem right now where the machine won't load the circuit boards (mot m, y, z, etc) due to the machine blowing the fuses. This was diagnosed by one of our engineers to be a problem with this part: MyData MyCronic Booster BNB/NREG L-0
Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Thu Apr 09 07:42:36 EDT 2015 | kevinb
Thanks for the info. We tried the reset button but no luck. The UPS is not powering up. We checked the incoming power and it was good. So we took the UPS out and took off the cover to check for blown fuses. We also checked the reset button and it
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Fri Sep 13 13:43:48 EDT 2002 | barryg
You right Simon, this forum is not for that type of question, but since you have been polite and desperate, i'll shoot some help. Your right, sounds like it is the unit, there is probably a component failed that is shutting down the unit when it gets
Electronics Forum | Tue Apr 05 12:01:17 EDT 2005 | blueflag
Thanks for reply we have found a blown fuse on the back plane for the mot-z pcb . But we now have problems with Z height, i am trying to auto-teach devices from the tray wagon (qfp etc) and it is not always lowering the nozzle to the component. i ha
Electronics Forum | Thu Oct 13 03:02:01 EDT 2016 | souldierann
I hope you could able to help me how come the fuse blown out when we powered up the board containing relays. The relays rated current is 80milliAmps only compared to the 2A fuse.The relay contact form is SPDT.
Electronics Forum | Thu Aug 26 23:56:34 EDT 2004 | valuems
Hello Ken We need to know if your in the USA? Would appreciate a phone call if you are. Have seen the fuse blown statement before, most of the time after the hard drive has been replaced. The # is 740-344-4260 Thank Harry
Electronics Forum | Sat Feb 16 16:14:20 EST 2013 | ericrr
Have you done a post-mortem on the blown fuse? Assuming it is a glass fuse, if it is all black around the glass then replacing the fuse will be pointless. (the new fuse will just blow again, making a black mark or BLACKER mark all around the glass)
