Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Thu Jul 28 17:35:45 EDT 2016 | travishemen
We have similar machines and they will give errors like this if the adjustable sensor on the unload end is over the fixed or movable rail.
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Mon Dec 03 14:49:23 EST 2018 | dleeper
Are they getting stuck inside the oven or at the very end? If thermal expansion is the problem the boards would be getting stuck in the reflow zone since that would be the hottest and therefore the point where thermal expansion would be the greatest
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)
