Electronics Forum | Fri Jul 16 13:41:24 EDT 2004 | Frank
I agree with everybody here. There are plenty of better options than what you have proposed. Without knowing your equipment brand, or what type of offline software you have, if any, I have a few suggestions. 1) If you don't have any offline softwa
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Mon Dec 11 19:28:51 EST 2017 | spoiltforchoice
That's not really the point of dual lane feeders. As a general rule having a dual lane 8mm feeder means the machines "slots" are actually 16mm, dual lanes on a 8mm feeder helps keep the overall lane density of a machine higher, its much easier to bui
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
| 1 |
