Electronics Forum | Tue Dec 21 09:22:52 EST 2010 | cwhite30
I have a camalot 1818 dispensing system, but it recently stopped booting up. It gets to the 197 vision initialization screen and then freezes with the message "bad command or file name could not communicate with vp" Does anyone know how to fix this?
Electronics Forum | Fri Jan 05 20:26:48 EST 2024 | kristi
I am in search of a boot disk for an Electrovert Econopak Plus. First our CMOS battery died, we wired a 3V battery to it and that works fine now. However now it's saying the diskette is unable to boot. The disk drive passes test, and I have installed
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Sat Apr 22 09:29:51 EDT 2017 | westshoredesign
One of our machines has somewhat randomly lost the ability to optimize programs. It freezes every time, without fail, during the initialization step (in optimizing). I don't believe there is anything wrong with the tabletop, or board program. I've t
Electronics Forum | Wed Aug 05 18:06:34 EDT 2020 | smittym
So I have a old TpSys system running on a TP9-2U and I can't get the initializing hardware when I boot the unit. Once the program loads the computer freezes if I select any of the drop menu items. I can however get it to initialize if I go into Servi
Electronics Forum | Fri Aug 04 12:53:49 EDT 2023 | georgegr777
Good afternoon everyone, I have this problem with my cp40cv machine. while booting this message appears: not allowed when placing, pause or freeze status. then I click OK and the next message is: LOADING SYSTEM DATA TO DPRAM IS FAILED. I click anoth
Electronics Forum | Thu Aug 16 08:15:04 EDT 2018 | muzzy
Hello! Does anybody know how to access the "MS Parameters" window on older JUKI Pick and place machines? (mainly on 730, 740, 750, 760). Service manual mentions that it is possible to change all of the mechanical parameters from there (like for examp
Electronics Forum | Mon Jun 12 09:42:49 EDT 2006 | mmjm_1099
Hello all, I am having an issue with my QP341 when it reads fiducials. It will be running fine than it will freeze when it goes to read a fid. When I reset the QP and it seems to work fine for a little bit than it will repeat itself and freeze up aga
Electronics Forum | Tue Mar 04 10:54:50 EST 2008 | vikkaraja
I think so,but what do you mean if hard drive is ok. Please explain.Computer boots up ok and machine even goes through it's complete intialization steps. I was thinking the same way as you are to start replacing one componet at a time. what do you th