Electronics Forum | Tue Oct 02 07:48:16 EDT 2007 | brendansales
Hi there, Does your computer has a product key (USB) by any chance? there are some units that requires a USB key. alternatively you can check if the controller has been opened before (you can check if the sticker has been torn), or you can try swit
Electronics Forum | Mon Dec 17 12:12:18 EST 2007 | Claude_Couture
in very rare occasion I had problems with BTU ovens, I contacted BTU directly and they were always helpful.
Electronics Forum | Mon Oct 01 19:44:49 EDT 2007 | marcelll
Just bought a used VIP 98 and I have an alarm. Computer don't communicate with the embedded controler of the oven. I've check the cabling, OK, and there's power on the controler. The PC is booting normally. The controler is plug in the serial port 2
Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab
Electronics Forum | Tue Jun 07 05:15:45 EDT 2005 | blueflag
Help Please could anyone advise when we run shutdown after 45 mins it should shut off . But we are still left with conveyor running also fans . regards Colin
Electronics Forum | Tue Oct 02 20:26:18 EDT 2007 | marcelll
Thanks for the help guys. I found that serial port 2 was bad on the computer. Not able to change it to com 1 in the config. Seems to be protected by a factory password. So I had to change the computer and reload the software. It's working now. Thank
Electronics Forum | Tue Oct 02 10:01:15 EDT 2007 | chrisgriffin
I once had a similar problem on a VIP98. The problem was with the FCU (furnace control unit). There was a burned IC on the lower left of the card. I don't remember what kind of part it was, only that it was very common and I got a new one from Dig
Electronics Forum | Mon Dec 21 12:52:51 EST 2009 | ryanmiller
I need to find someone that can do an install and general training for a BTU VIP98N, in the Cleveland area, quickly. Please let me know if you or someone you are familiar with can provide that service. Thank you. Ryan Miller 214-403-7886 rmiller@d
Electronics Forum | Fri Dec 07 02:10:26 EST 2007 | mpolak
Hi, Could you guys verify my BTU VIP98N oven settings for lead free process. At the moment as my standard profile im using these settings 140 160 180 207 205 220 257 same temps for bottom and speed 50cm/min. Has anyone got same oven and could
Electronics Forum | Tue Jun 10 18:48:42 EDT 2008 | mefloump
We run 2 lines: Line 1 has a Dek 265, GL5, CP43, QP242E, and Heller 1900W; Line 2 has an Ekra X4, GL541, CP643E, QP242E, and BTU VIP98N oven. Soon both lines will have new Ekra X5 screen printers and the BTU replaced with another Heller. Works for us
