Electronics Forum | Thu May 18 11:55:15 EDT 2006 | RLM
Is a Juki feeder a stand alone unit or does it need to communicate with the assembler ? I can operate a Quad feeder just by hooking it up to a proper voltage source. No need to communicate with a computer. If the Juki's will operate this way maybe I
Electronics Forum | Thu May 18 17:34:06 EDT 2006 | Frank
The Juki tape feeders are mechanically actuated. There is a knock pin on the bottom of the feeder bank that will push up to advance the feeder.
Electronics Forum | Sat May 13 00:25:00 EDT 2006 | George S
My Juki 0201 feeders work very well, but I don't know if they can fit your machine
Electronics Forum | Tue May 16 14:21:42 EDT 2006 | Frank
Juki feeders will not work on Quad or Tyco machines. Unfortunately, (or fortunately - depending on how you look at it) there are not many, if any, cross-platform feeders. Heck, some vendors can't even swap between models of machines that they sel
Electronics Forum | Sun Jun 14 17:05:48 EDT 2020 | yakout
Dear friends i need to know how to calibrate the 12mm yamaha feeder thanks yakout
Electronics Forum | Tue Dec 05 09:59:24 EST 2006 | sigmasmt
This is for CP6 feeders? What is the smallest componet run on this machine(0402,0603)?
Electronics Forum | Thu Dec 21 13:12:08 EST 2006 | johnw
Here you go guys check this out Information on the Alternative Feeder Master www.feedermaster.com
Electronics Forum | Mon Jun 15 21:18:42 EDT 2020 | yakout
that is my feeder image
Electronics Forum | Wed Dec 20 22:54:28 EST 2006 | fastek
I think that in this day and age.....if you are not testing the feeder via some sort of indexing proceedure while the feeder is off of the machine.....you are simply not going to be certain the feeder is working properly. The Alternative SMT jig do