Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Tue Feb 25 01:32:12 EST 2020 | kcgoh5666
LOOKING FOR THIS CAMALOT GEMINI II Z AXIS BOARD
Electronics Forum | Tue Oct 20 10:31:50 EDT 2009 | lloyd
Seth, From the Siemens technical information document: Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star i
Electronics Forum | Tue Mar 18 11:02:44 EDT 2014 | proy
I have a Camalot MOtion control board which does not control its Z axis properly. Can anyone here recommend someone who can repair this? Peter
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Sat May 30 13:16:39 EDT 2020 | davef
Parts & Supplies * "Send RFQ" tab [pumpkin colored tab mid-upper part of page]
Electronics Forum | Tue Oct 14 14:08:22 EDT 2014 | dilogic
No, each card in LP servo rack drives only one motor. But there is an servo cotnroller board (actually 3 of them) in the VME rack (where all computers are). Third one from the left(slot13) controls head2 theta and z axis. That might be a cause of you
Electronics Forum | Sat Aug 19 08:01:39 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
Electronics Forum | Sat Aug 19 08:14:25 EDT 2006 | johnw
I am experiencing the same problem just now on one of my FCP643 machine only when I change program and the machine moves to load position to clamp the board, as soon as I get to the bottom of this I will let you know.I suspect its the Z-AXIS loader c
| 1 |
winsouce.jpg)