Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Sun Feb 11 12:12:48 EST 2007 | dilogic
Just out of curiosity - is it possible to enter placement positions in interactive mode (using camera image) on the GSM1 series? - Deni
Electronics Forum | Wed Apr 07 11:36:41 EDT 2004 | stefwitt
Your machine will have to have a reference position. From this reference position, you determine all other machine positions. If the camera is attached to the head, you could place a glass slug and measure camera-nozzle offset, by placing the slug w
Electronics Forum | Thu Apr 08 23:08:56 EDT 2004 | Ken
Well, the precision glass is for upward looking camera's. It essentially is a "perfect part". Vapor deposition lithography on glass (for Cte stability)....basically the part pattern (or part fids) is compared to its target location (same pattern on
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Thu Oct 24 23:19:55 EDT 2013 | wesleyintelli
Heads 2 & 3 on our CP45 are placing poorly. We believe that the head cameras are adjusting the component positions incorrectly since the placement is perfect when vision alignment is turned off. Does anyone have any experience with this issue or acce
.png)