Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Thu Dec 29 09:03:03 EST 2016 | sumote
I would cut a piece of cardboard to the same dimensions as your circuit card. Run that through the fluxer of your machine and pull it out before the pre-heater. Take a look at the cardboard and verify that flux has been sprayed on it. That board look
Electronics Forum | Thu Sep 27 19:52:28 EDT 2001 | davef
All of the discussion of "environmental controls" are a matter of degree, dependent on the requirements of the product that you manufacture. For example: shops assembling under-the-hood products have different requirements than shops making garage d
| 1 |
.gif)
