Electronics Forum | Tue Mar 20 12:33:08 EDT 2018 | edjeske
how do i clear this error?
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 19:35:38 EDT 2018 | dekhead
Not sure what blowing an airline would have to do with this; I sent you an email to get information on machine specifics for the procedures you need.
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Mar 29 03:03:42 EDT 2016 | wesleyintelli
Our MPM UP100 is not slowing the pcb carriage as it is brought under the stencil. The result is that the carriage jolts the machine heavily when it is fully loaded. The hall effect vane sensor half way along the rear rail is working correctly. The le
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Tue Oct 09 14:59:52 EDT 2001 | slthomas
That's what we do with our MSHII's...setup one carriage offline while the other one runs. We also have setup carts to load the feeders ahead of time and haul them out to the lines. Of course, when we exceed the carriage capacity of 75 slots for an
Electronics Forum | Tue May 25 18:03:38 EDT 2004 | fastek
Also CP-7's have that feeder carriage quick change option which allows you to pull out the whole feeder carriage via a quick change cart and replace it with another one.
Electronics Forum | Fri Jun 11 11:42:14 EDT 2004 | Claude_Couture
hum, I see no problem for your people supporting any line that can run this speed. If your chip shooters are the dual feeder carriage kind, you must run them in replace mode, when one feeder runs out in one carriage, it parks it and continues running
Electronics Forum | Thu Mar 16 11:33:52 EST 2006 | cyber_wolf
When I flip the switch to lock the stencil, the magnet in the carriage cylinder pops free..... Any ideas ?
