Electronics Forum | Sat Dec 05 22:08:21 EST 2009 | casmt
MY9 - 19 are all the same machines. The frame is only bigger. With the 19 you can get up to 256, 8mm feeders if it has the stand table. Ocourse that is an advantatge it can handle large boards with a big table. I have used Mydata a many companys. A
Electronics Forum | Thu Oct 20 17:03:56 EDT 2022 | rgduval
As much as I love MyData machines, if you are low mix high volume, they may not be the best solution. They have their place in the mix, but, I believe their greatest value is in high mix environments. Not to say that the My's won't do the work, the
Electronics Forum | Wed May 25 22:32:28 EDT 2016 | stevedc
So, I haven't used my Quad 4C for a while and when I started everything back up to run a new board it appears that the Quad align is in need of calibration. When I pick up a component and do an LAE measurement on it it shows the part center location
Electronics Forum | Tue Sep 16 15:54:39 EDT 2014 | gascon5383
I have not tried running it 180 or 90 degrees out. The process involved to change that would be too large for my company to accept it. I see where you can adjust the board stop x and y but is there a way for the z axis? I have found that the board is
Electronics Forum | Thu Aug 05 20:33:48 EDT 2004 | Dhanish
The machine type is Fuji CP6.We have major issues with Network Resistor placement.The equipment guys often feedback there is a problem with nozzle and feeders.What will happened to the part if the Thickness data in the Part Data does not match the Pa
Electronics Forum | Wed Nov 05 19:57:35 EST 2003 | Hoss
9.0. In it's spent form (from a batch cleaner) the cleaning solution is at a pH of 10.1. Luckily, we are setup with a holding tank and have an oppurtunity to treat the stuff before sending to drain. My question is, what is the easiest way to adjus
Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Thu May 27 10:04:27 EDT 2010 | cyber_wolf
I doubt that you will gain any advantage from stainless jaws. I think the stock jaws have beryllium inserts in them. I am pretty sure beryllium is harder than SS. Maybe stainless jaws with carbide inserts in them would work better ? Or what about c
Electronics Forum | Thu Feb 12 14:45:10 EST 2015 | barryg
I can only speak for Mirtec, and no I am not affiliated with them at all. We have had a Mirtec AOI for at least 9 years. We have never had any major issues with it. There support is very good and usually they get right back with you if you cannot get
Electronics Forum | Fri Oct 18 14:35:13 EDT 2019 | tey422
If all other tools appear to be working fine, only the A12 is having the issue. You might have a faulty tool(not within original spec). As Bruce suggested, check the A12 tool itself to see anything abnormal. If it's brand new, you might need some lub