Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Wed May 06 23:46:31 EDT 1998 | Thomas Nisbet
We want to insert LED's on .100 center's with a UIC Rad 2. The LED must have plastic standoff on the leads before they are inserted. Are there any tape & reel machines that will put the standoff on the LED and then put the component on tape & Reel. A
Electronics Forum | Mon Jun 01 12:31:35 EDT 1998 | Don Spicer
| We want to insert LED's on .100 center's | with a UIC Rad 2. The LED must have plastic | standoff on the leads before they are inserted. | Are there any tape & reel machines that will | put the standoff on the LED and then put the component | on ta
Electronics Forum | Tue Aug 01 09:27:13 EDT 2017 | tmennink
Hi all, We are having a lot of trouble with mis-pick trying to place silicone dome LEDs(3535 package) It seems that the silicone of the LEDs is sticking to the side wall of the carrier tape pocket. The vacuum nozzle would normally suck up the led an
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Tue Mar 30 17:52:15 EDT 2010 | cusackmusic
They are very finiky. If you have good solder paste, and a slight down pressure, to make sure the LED is "stuck" to the board, you should be able to place it. Pick it up on the center of the flat, NOT the lens. Even with the vacuum turned off, t
Electronics Forum | Fri Dec 08 16:54:42 EST 2006 | flipit
My experience with SMT LED packages is that certain LED package styles tend to float. This floating is caused because the LED is often only terminated on the bottom side of the LED package. Sometimes the LEDs are terminated like a SMT resistor with
Electronics Forum | Sat Apr 03 16:39:15 EST 2004 | stefwitt
We had a similar system on the Siemens machines, quite some time ago. However, it was not a laser light but a LED and a fiber cable. Actually the center fiber or receiver was surrounded by a bundle of small fibers for the LED light source. You may al
Electronics Forum | Wed Oct 02 18:26:49 EDT 2019 | tey422
First of all, General Vision for Juki is not easy to learn/understand, it would be the last option if other centering method fails; only advance Juki package programmer would want to play with General Vision. If possible, using laser recognition woul