Electronics Forum | Tue Feb 27 22:40:28 EST 2007 | davef
IPC-A-600G, 2.9 Solder Resist [Solder Mask] [snip]"Solder resists are used to limit and control the application of solder to selected areas of the printed circuit board during assembly soldering operations and are sometimes used to reduce dendritic f
Electronics Forum | Tue Jun 22 00:20:21 EDT 2010 | leadthree
Pick & Place > Wave-solder > other parts > test > conformal coating Is there any production error that could make a ceramic cap conductive? PS: want to add one point: The caps don't seem to be cracked. We changed a few 100 and didn't notice any bro
Electronics Forum | Wed Jun 30 00:20:08 EDT 2010 | leadthree
Thanks for your reply. This production lot is already finished. We produced in 2 lots, first was no-clean (and was ok), 2nd lot was cleaned (aqua based), and I need to look into the cleaning further. Since it's all finished I can't get parts from se
Electronics Forum | Fri Jun 06 06:11:18 EDT 2014 | paulg
I have a large monoblock ceramic filter on a PTFE based pcb material. The filter has a metal casing soldered onto the ceramic filter. I am concerned that if the heating rate is to rapid, then thermal shock / differential expansion could cause the fil
Electronics Forum | Fri May 25 08:06:19 EDT 2007 | davef
Soldering PTFE boards * Exposure to the high temperatures needed for solder reflow poses no problem of loss of peel strength since the exposure times are relatively short. * There are many different types of PTFE based products that may perform diff
Electronics Forum | Thu Jun 24 11:21:40 EDT 2010 | floydf
Hi, > > I have a 100nF 0805 ceramic cap (the most > common type!), Yageo brand (20+ pcs. on the > module). In our production run I get some errors > due to conductive caps (can be anything from 25 > Ohm to 5K - most are open of course). Only one
Electronics Forum | Tue Jun 29 14:55:22 EDT 2010 | rgduval
For the capacitors that Yageo analyzed... Were they taken out at representative points in the process?? ie. were samples taken from pre-assembly, pre-ICT, post-conformal coat, post-final test? You note that the parts 'seem' to be ok up to ICT. And
Electronics Forum | Thu Apr 17 17:38:57 EDT 2003 | Takfire
Dave, I am not exactly sure what is driving them to believe that this is a capacitor issue. It is unfortunate, that this belief has slowed their activity in further understanding their manufacturing process. The caps are BME (Base Metal Electrode
Electronics Forum | Mon Aug 07 10:22:13 EDT 2000 | genglish
Ramon, I have had experience in the problems you are witnessing. The problem can relate to a number of factors. Obviously the printing process is the first place to start your investigations, try looking at the stencil apertures for bleed under the
Electronics Forum | Mon Aug 09 18:03:28 EDT 1999 | Earl Moon
| | I am having cleaning problems when processing PCB's which have | | TAIYO solder mask on them. After processing, hand soldering and | | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other solde
.gif)
winsouce.jpg)
