Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Wed Aug 24 11:32:08 EDT 2016 | mnorthey
Did you get your problem solved? I don't remember exactly what I did for that problem but it may have involved changing a servo or driver card. I do have a copy of the calibration/repair manual if you want it. I also have some Nozzles NC-1410 (1.0
Electronics Forum | Mon Aug 08 08:32:42 EDT 2016 | emeto
Just get a regular scale(small thin one - like a scale for kitchen). Mount it over a PCB and simulate placement with certain force. Hold the nozzle down for long time in order to register accurate reading from the scale. Then, just change parameters
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Thu Sep 08 15:45:21 EDT 2016 | claudea2
Thanks Bob, I will change the z-rod just to make sure. It is a tall part read at 180. The nozzle height bugs me because we have 3 machines and the first one has a nozzle height of 238 while the 2 others around 200. I am thinking this parameter may ad
Electronics Forum | Wed Nov 09 09:08:40 EST 2016 | sumote
We are currently running FUJI XPF lines and > receive all of our RF shields in T/R format. > The large shields we use come on a reel of 500, > the small shields come on a reel of 800. both > much more efficient than using trays. I agree. Get
Electronics Forum | Fri Nov 18 15:45:27 EST 2016 | jg_annaanthan
Hi all, my site using x-ray machine "Agilent 5DX Series 5". The tester will hang around 10- 15 min during perform automatic startup at level "Delta Z". My site, we already change Front & Rear laser, burn galil, performed manual startup, total shutdow
Electronics Forum | Sun Nov 27 05:04:02 EST 2016 | pmcg
Never used stainless pots as when we converted to lead free we changed all the pots to titanium. Been using SN100C for many years now, very good results, also use it in reel form in our selective solder machines with great results. Bear in mind the
Electronics Forum | Tue Dec 27 06:52:34 EST 2016 | luciano
Thanks for your advice. I've tried setting the temperature up and even measuring the temperature at the wave itself but had no luck at all. I've also tried using temperatures going from 245 ºC up to 260 ºC. The amount of flux was adjusted as well a
.gif)
