Electronics Forum | Wed Dec 06 17:22:03 EST 2023 | madisreivik
Hello and help ! After changing oil hose, cleaning machine and all nozzles, CP642 narrow camera started to flicker. And in nozzle centering measuring, no image at all. We checked syncro pin, seems ok. Also checked camera picture with Sony monitor,
Electronics Forum | Fri Dec 08 17:31:17 EST 2023 | madisreivik
Changed camera, flicker is gone. But cannot calibrate nozzle centers with the narrow camera, error all time I checked buffer image, brightness and contrast is SAME as with wide camera. Center of camera is roughly aligned using nozzle, its better
Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr
Check your gel flex. They're no good. Don't use em. good Luck pr
Electronics Forum | Mon Dec 18 14:06:10 EST 2023 | cyber_wolf
I would check with these guys. One or both most likely have these jigs. http://www.ibesmt.com/ https://www.smtresearch.com/
Electronics Forum | Fri Dec 08 19:02:12 EST 2023 | madisreivik
Found the main problem During messing around (hopelessly :) we had found the calibration menu and pressed "check". Machine thought that there was a calibration nozzle (maybe 10x10mm square) but in reality, there was d=1.0mm nozzle. Machine decided
Electronics Forum | Mon Sep 02 15:20:48 EDT 2013 | aemery
Interesting! not the usual error. In my experience when the vision cables get damaged it shows up and white noise flashes across the monitor. The connections are the easiest to check so here's your system layout with connection points. Starting at
Electronics Forum | Wed Nov 19 10:57:55 EST 2014 | jimmyboz
Oh yeah, You can flip to switch on the camera card, VM1710 and jog the PCB under the fiducial camera to visually inspect to placements. switch it back when you are done.
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Thu Jan 19 11:10:13 EST 2017 | rgduval
I'd start by checking the manufacturers documentation, and seeing if they have any application notes regarding reflow recommendations for the part. But, in general, make sure to bake the parts prior to assembly, they are notoriously moisture-sensiti
