Electronics Forum | Thu Feb 03 12:21:15 EST 2005 | Chunks
Lets get to the simple things. Wave or Reflow? Wave soldered parts have a higher susceptibility to physical damage until they are waved. That�s were I normally see this type of break. Usually, the crack is a circular pattern in the cap if it�s fr
Electronics Forum | Thu Mar 26 11:25:21 EST 1998 | Earl Moon
In December and January (1997 & 1998) a number of people requested information regarding component cracking. I overlooked this until recently thinking design and process requirements were violated. After reviewing the last 14 months consulting effort
Electronics Forum | Wed Dec 31 08:55:09 EST 1997 | justin medernach
| Has anyone had any experience with thermal shocking | and cracking of SMD capacitors during the rework process? | My company was advised to preheat capacitors to 125 C | at a rate of 2 C/sec before replacing them onto boards. | Would this maybe
Electronics Forum | Sun Jan 11 11:28:14 EST 1998 | Bob Willis
Most componnent cracking is mechanicaly produced a guide to causes of capacitor damage is included as a download file on my web page www.bobwillis.co.uk I feel that the supplier is looking to blame some one else. IPC make comment on pre heating chip
Electronics Forum | Sun Jan 11 11:28:12 EST 1998 | Bob Willis
Most componnent cracking is mechanicaly produced a guide to causes of capacitor damage is included as a download file on my web page www.bobwillis.co.uk I feel that the supplier is looking to blame some one else. IPC make comment on pre heating chip
Electronics Forum | Tue Jun 22 08:37:52 EDT 2010 | davef
Dennis: These "terminal detach failures" probably are caused by thermal shocking of the components. * Preheat the components * Use a hot air pencil rather than a soldering iron
Electronics Forum | Tue Feb 28 16:09:27 EST 2006 | outgasser
Does anyone have any insight as to the cause of cracked chip capacitors during SMT? Z-stop? Thermal shock? Any help is appreciated.
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
Electronics Forum | Mon Jun 30 10:52:36 EDT 2003 | Bob
Suggest you ask vendor for a failure analysis. Ceramic chips have specific signatures for mechanical or thermal shock cracking. The vast majority of failures are due to mechanical flex. Depanelization and secondary operations such as hand insertion
Electronics Forum | Mon Jun 18 01:09:03 EDT 2001 | Dean Stadem
Igmar, If these parts are epoxied in place, and subsequently wave soldered, I would bet you a cup of coffee that they are cracking due to the thermal shock of the wave. Typically there is a valley or dip in the temperature after the pre-heat in the w
winsouce.jpg)
