Electronics Forum | Fri Apr 11 11:26:09 EDT 2003 | Brian W.
Cracked capacitors usually are not found at ICT. Unless the cap is completely cracked, the capacitance may not change much, and the usual failure mode is a leakage current. This is usually only seen in ESS type testing, when temperature and humidit
Electronics Forum | Thu Sep 11 15:23:31 EDT 2003 | Peter L.
I have come across a rash of failed assemblies that have 0805 capacitors and resistors, bottom side glued, wave soldered and washed. Trouble shooter reported touching up the solder joints on a few areas and the boards would pass test. I had a look a
Electronics Forum | Tue May 25 07:03:34 EDT 1999 | Milan Z.
After reflow proces in convection-IR oven we find broken body of SOT23 elements. There is no problems on other elements (SOIC, chip R,chip C, etc) Where is the problem? Thanks in advance!
Electronics Forum | Thu Mar 15 05:59:08 EST 2001 | PeteC
Good point. I'm having trouble with the words "electrical elements" in the J-STD. Is a marking an "element" ?? An upside down chip resistor is certainly not a defect in that it does not negatively impact product functionality or dependability. I sugg
Electronics Forum | Wed Nov 13 02:28:27 EST 2019 | trino
Hello, I am a Japanese engineer. I am sorry for my unskillful English. Have you ever encountered cracks in chip resistors or IC components due to board mechanical stress? Especially, I'm looking for a case in the PCBs Depaneling process(pizza cutte
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Wed May 26 18:04:16 EDT 1999 | John Thorup
| After reflow proces in convection-IR oven we find broken body of SOT23 elements. There is no problems on other elements (SOIC, chip R,chip C, etc) | Where is the problem? | | Thanks in advance! | Check your profile at the site of cracked component
Electronics Forum | Thu Mar 14 09:07:26 EST 2002 | cfraser
I can not tell you what the actual stress limits are. I can tell you that de-paneling PCB's by hand is a very poor choice. I have seen numerous accounts of cracked caps, resistors, and LED�s due to incorrect de-paneling procedures. I would recommend
Electronics Forum | Mon Mar 22 05:39:36 EST 1999 | Bob Willis
Has any one seen failures of chip resistors after 1-2 years where the junction between the silver termination and the restive element on the top of the ceramic has corroded through. This results in a high resistance failure after this period of time.
Electronics Forum | Mon Nov 18 20:30:39 EST 2019 | alanyang
The chip resistors are placed on the edge of the board, but the board has no or enough waste tabs. When de-panelizing, the bits may contact and break them. You can use a smt carrier, or add waste tabs in your next assembly manufacturing.
