Electronics Forum | Thu Oct 05 16:48:41 EDT 2000 | LarryK
Has anyone ever used the circuit repair kits? The type where you can replace a PTH or SMT pad that has been lifted or damaged? It appears that you just select a pad, trace or whatever needs replacing from a panel and heat or glue it onto the board.
Electronics Forum | Fri Oct 05 07:46:24 EDT 2001 | george
Specifications of testing force are not fixed, but (incase of wave soldering) the value should be at least 120-150 % of the force the wave. So for small chip components we assume that the force from the wave on the component is about 3 Newton, this m
Electronics Forum | Mon Aug 21 15:02:53 EDT 2006 | FredC
If you really have Loctite Super Glue it is a cyanoacrylate and can be removed with acetone. If you have a Loctite aneorbic glue that has not hardened yet, acetone will remove it. If an anerobic has hardened I know of nothing that will remove it. Als
Electronics Forum | Fri Oct 06 08:00:41 EDT 2000 | jackofalltrades
We use both, old boards and repair kits with equal success. Contact East (http://www.contacteast.com/) has a nice selection of kits depending on your needs, beginner v.s. experienced.
Electronics Forum | Mon Apr 17 19:44:20 EDT 2000 | Dave F
Ashok: Well, your customer probably has a good reason for wanting you to send them boards without holes in the solder mask. What is their goal for the mask capabilities after you get do reworking the boards? * Cosmetic surface coat? * Performance t
Electronics Forum | Wed Aug 09 19:14:15 EDT 2006 | Board House
Our Manufacturing policy regarding welds is as follows. 1) Inner layers - depends on Core thickness and line width. Our shop will not do any welding on core thickness less then 5 mils. or line width less then 5 mil. Good AOI practices reduce the a
Electronics Forum | Thu Oct 05 17:05:36 EDT 2000 | JAX
These types of foil kits work just fine as long as they are used before expiration. Scraping off the epoxy coat gets a little tough on fine pitch pads and etches. I have always like to use a solder sample board to retrieve my bits & pieces from whene
Electronics Forum | Thu Nov 16 18:41:17 EST 2006 | John Fisher
Unidec repairs of industrial electronics specializing in the surface mount (SMT) and through-hole circuit board equipment, robotics, vision systems and general automation. Plese see our website at http://www.unidec.com of call toll free at 888-701-00
Electronics Forum | Tue Oct 16 09:17:10 EDT 2001 | davef
Look at "Microcanyons", Circuits Assembly magazine, December 1998. There D Pauls & T Munson describe adhesive on boards that was cured too rapidly and formed a skin that trapped volatiles and solvents. The volatiles and solvents created long voids i
Electronics Forum | Wed Nov 13 22:30:05 EST 2002 | davef
Methods for performing repairs: * 7721 - Repair & Modification of Printed Boards & Electronic Assemblies. * On-line guides at Circuit Repair Technology [ http://www.circuittechctr.com ] site. Roughly from East to West, service companies that perfor
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
winsouce.jpg)
